Used GAF vertical stainless steel filter model
RB1BSL-SE-2F. Vessel #9140-C rated 150 psi @ 225
degrees F.
25182
Filter
SS
Used GAF vertical stainless steel filter model
RB1BSL-SE-2F. Vessel #9140-B rated 150 psi @ 225
degrees F.
25183
Filter
SS
Used GAF vertical stainless steel filter model
RB1BSL-SE-2F. Vessel #9140-D rated 150 psi @ 225
degrees F.
25184
Filter
SS
Used GAF vertical stainless steel filter model
RB1BSL-SE-2F. Vessel #9140-A rated 150 psi @ 225
degrees F.
Filter Belt
Item ID
Category
Capacity
Material
Description
25151
Filter Belt
2
304 SS
Used Andritz model CPF2.0 SMX58-LP9317 belt filter
sludge press. 2.0 meter capacity. Left hand drive.
84" wide belt. T-304 stainless steel construction. Hot
dip galvanized frame. Rated 375-750 pounds/hr dry
solids. Hydraulic through put 75-150 GPM. Consists of
(3) dewatering zones. 1- gravity zone (6) rows of
horizontal plow chicanes. 2 wedge zone- mechanical
pressure applies by means of wedge. 3-S-Roll zone (8)
rolls achieves high pressure through serpentine wrap.
Includes belt tensioning with parallel guide, cleaning
device, belt tracker, and doctor blades. Belt speed 1.6
FPM @ 15 Hz - 9.4 FPM @ 90 Hz. 5 HP 3/60/460 volt
eurodrive. Includes controll panel, pumps, and motors.
Venturi mixer - mixes sludge and polymer prior to head
box. Fluid dynamics hydro action water polymer blending
system an 14" x 20' belt take off conveyor.
Filter - Centrifugal Discharge
Item ID
Category
Capacity
Material
Description
24853
Filter Centrifugal Discharge
265
316L SS
Used Schenk centrifugal discharge filter type ZIFF-SR
15/10 KLKB1. Pressure leaf design. T-316L SS. Jacket
T-304L SS. 265-gallon fill capacity. Internal rated
100/FV @ -4o to 300oF. Jacket rated 100/FV @ -4o to
300oF. Tapered vessel ILK design. Automatic cake
discharge with scraper device. 10 sq. meter filtration
area. 23 filter elements. 300 liter usable cake
volume. Seals are dry running, double acting mechanical
type. 805 MM diameter of filter element on 40 MM
spacing. Driven by a 20 HP 3/60/460 volt 1800 RPM
motor. 12” diameter butterfly discharge. New in 1998.
25065
Filter Centrifugal Discharge
265
Hastelloy
Used Schenk centrifugal discharge filter type SR-SR
15/10 KLKB1. Pressure leaf design. Hastelloy C-22
wetted parts. 265 gallon fill capacity. 16 gallon
capacity heated jacket. Internal rated 100/FV @ -20 -
150 o C. Jacket rated 100/FV @ -20 - 150 o C. Tapered
vessel ILK design. Automatic cake discharge with
scraper device. 10 sq. meter filtration area with
upgrade capability to 15 sq. meter. (20) filter
elements, (1) separation filter element, and (2)
scavenge plates. Seals are dry running, double acting
mechanical type. 12” diameter butterfly discharge.
Built 1999. Driven by 20 HP 3/60/460 volt 1800 RPM
motor.
25066
Filter Centrifugal Discharge
265
SS
Used Schenk centrifugal discharge filter type SR-SR
15/10 KLKB1. Pressure leaf design. T-316L stainless
steel. Jacket T-304 stainless steel. 265 gallon fill
capacity. Internal rated 100/FV @ -20 - 150 o C.
Jacket rated 100/FV @ -20 - 150 o C. Tapered vessel ILK
design. Automatic cake discharge with scraper device.
10 sq. meter filtration area. (20) filter elements, (1)
separation filter element, and (2) scavenge elements.
300 liter usable cake volume. Seals are dry running,
double acting mechanical type. 805mm diameter of filter
element on 40 mm spacing. 12” diameter butterfly
discharge. Built 1996. Driven by 20 HP 3/60/460 volt
1800 RPM motor.
Filter - Nutsche
Item ID
Category
Capacity
Material
Description
24839
Filter Nutsche
0.2
316L SS
Used Rosenmund 0.20 Sq. meter filter. Constructed of
T-316L stainless steel on all contact parts. 20”
diameter X 36” straight side. Shell rated 90 PSI @ 350
degrees F. Jacket T-304 stainless steel rated 100 PSI @
350 degrees F. Shell surface area 13.65 Sq. ft. Shell
volume 40.85 gallons. Equipped with hydraulic drive 5
HP power pack to raise and lower agitator assembly.
Agitator output speed 5-25 RPM.
24844
Filter Nutsche
2.5
Hastelloy
Used 2.5 Sq meter Cogeim Filter/Dryer item # F-221
constructed of hastelloy C22 on all contact parts.
Volume 825 gallons, 3.02 cu. meter working capacity.
Electro-polished interior. Shell rated 87/FV @ 350oF.
Half pipe coil jacket rated 116 PSI @ 350oF. Side
discharge, movable bottom with bayonet ring. Perforated
filtering bottom with center bottom discharge for batch
liquors. Includes hydraulic cylinders for lowering.
Oleo project hydraulic package and controls. Mounted
on carbon steel legs and bottom filtering assembly has
legs with caster wheels. Built in 1994.
25241
Filter Nutsche
45
Glass Lined
Used 2.8 sq ft (0.26 sq meter) glass lined De Dietrich
portable nutsche filter with approximately 45 gallon
capacity. 23 5/8" outer diameter x 30 5/8" deep.
Internal rated 100/FV @ -20 to 500 degrees F. Jacket
rated 90/90 @ -20 to 500 degrees F. Filtering plate has
(64) 1" holes. Equipped with hydraulic two seep hand
pump for lifting of sections and for swiveling cover
after lifting. Glass #3009. Built in 2000. Top
fittings: (1) 4" hand hole (with sightglass) and (2) 1
1/2". 2" center bottom drain.
25242
Filter Nutsche
52
Glass Lined
Used 3.1 sq ft (0.30 sq meter) glass lined Estrella
portable nutsche filter with approximately 52 gallon
capacity. Internal rated 50/FV @ -20 to 400 degrees F.
Jacket rated 87 psi @ -20 to 400 degrees F. 24"
diameter x 25 1/2" deep. Fittings top: (2) 4"
sightglasses and (3) 2". 2" center bottom drain.
Equipped with 2 stage hand operated hydraulic jack for
lifting sections. Glass# 2505. Filter in plate has
(151) 1" holes.
Filter - Plate and Frame
Item ID
Category
Capacity
Material
Description
25233
Filter Plate and Frame
11.2
316 SS
Used Sperry 30" T-316 stainless steel plate and frame
filter press. Type AHCP-111. Style RSB. 134.2 sq ft
filtering area. 11.2 cu ft cake capacity. Equipped
with (5) #47 steam heated plates. (4) #49 steam heated
plates. (11) #48 2" thick frames. (1) #47 heated head
plate (1) heated end plate and (1) dummy plate. (2) 2"
top feed and wash inlet. (2) bottom wash and filtrate
outlet. Rated 100 psi @ 250 degrees F. Air over oil
automatic hydraulic closure with power pack and
controls. Overall dimensions: 43" wide x 58" high x
10-6 long. Hydraulic rated 3000 psi.
25234
Filter Plate and Frame
11.2
316 SS
Used Sperry 30" T-316 stainless steel plate and frame
filter press. Type AHCP-111. Style RSB. 134.2 sq ft
filtering area. 11.2 cu ft cake capacity. Equipped
with (10) steam heated plates. (11) 2" thick frames.
(1) heated head plate (1) heated end plate and (1) dummy
plate. (2) 2" top feed and wash inlet. (2) bottom wash
and filtrate outlet. Rated 100 psi @ 250 degrees F.
Air over oil automatic hydraulic closure with controls.
Overall dimensions: 43" wide x 58" high x 10' 6" long.
Hydraulic rated 3000 psi.
25063
Filter Plate and Frame
316 SS
Used Sperry 30” plate and frame filter press with
approximately 134 Sq ft. filtering area, 11.2 cu ft.
cake capacity. Unit consists of 9 plates, 2 head
plates, and 10 frames made of 316 S/S. Also contains 1
dummy plate made of cast iron. Each of the 10 framed
chambers is 2” thick. Pneumatic powered hydraulic
closing unit consumes 5.5 SCFM @ 80 psig while closing,
working pressure 2800 psig. Plate types (4) #47 steam
HTD, (5) #49 steam HTD, (1) #47 steam HTD head plate,
and (1) #49 steam HTD head plate. Design parameters:
100 psig @ 250 o F. Dimensions: 56” high x 11’ long.
Built 1990,
25064
Filter Plate and Frame
316 SS
Used Sperry 30” plate and frame filter press with
approximately 134 Sq ft. filtering area, 11.2 cu ft.
cake capacity. Unit consists of 10 plates, 2 head
plates, and 11 frames made of 316 S/S. Also contains 1
dummy plate made of cast iron. Each of the 11 framed
chambers is 2” thick. Pneumatic powered hydraulic
closing unit consumes 5.5 SCFM @ 80 psig while closing,
working pressure 2800 psig. Plate types (5) #47 steam
HTD, (5) #49 steam HTD, (1) #47 steam HTD head plate,
and (1) #49 steam HTD head plate. Design parameters:
100 psig @ 250 o F. Dimensions: 56” high x 11’ long.
Built 1990,
Filter - Reverse Osmosis / Ultra
Filtration System
Item ID
Category
Capacity
Material
Description
24860
Filter RO/UF System
400
316 SS
Used Millipore Corp. ultra filtration model PUF-400 XP
process system. Includes (4) T-316 stainless housings.
Each can hold (2) 50 Sq. ft spiral wound ultra
filtration (UF) helicon cartridges mounted in series,
each housing with these type filters would represent 100
Sq. ft membrane area. Total membrane area is 400 Sq.
ft. The control system utilities hardware and software
T. Perform automated processing & Data management.
Allen-Bradley SLC-5/04 controls. Includes Rockwell
RSLogix 500 software. Includes feed and retentate
pressure transmitters, flow meters, permeate
conductivity sensor, and Bebco purging unit. Built
1999. Includes all stainless sanitary piping, valves,
and S/S stand.
24859
Filter RO/UF System
1200
NA
Used Millipore PRO-8/4 XP process reverse osmosis
system. Includes: (2) T-316 S/S ASME CODE stamped
housings. Each housing can hold (2) 300 Sq. ft. nanomax
cartridges representing 600 Sq. ft total membrane area.
Total system can house 1200 Sq. ft. membrane area. The
control system utilities hardware and software T.
Perform automated processing and data management.
Specific control functions and interlocks are performed
by the PLC Allen-Bradley SLC-5/04 controls. Specific
PLC hardware: 1747-L542 SLC-5/04, 1746-N18 Analog input
modules, 1746-1B16 16 point DC digital input module,
1746-0B16 16 point DC digital output, 7 slot rack.
Rockwell RSLogix 500 software was the PLC software used
to develop, debug, and document all code associated with
PLC. System includes (1) Goulds 3335 100 HP centrifugal
pump, which must be fed by a supply pump provided by the
customer, shell and tube 24 sq. ft heat exchanger, and
Bebco purging unit. Stainless piping and valves
installed with sanitary tri-clover clamps. Mounted on a
S/S frame. Built in 2000.
